Whether you prefer the enjoyment of washing by hand, or the power of using a pressure washer and foam cannon; achieve thick, long-lasting foam with Armor All Shield Snow Foam Car Wash. This car shampoo gets to work on lifting dirt and road grime, fast. Its heavy-duty, high-foaming formula helps create a thick foam that clings to the bodywork, allowing it to interact and loosen dirt. Use with a traditional bucket and sponge routine, or with a foaming cannon and pressure washer. If using a bucket, rinse your car to remove excess road film, dirt and grime. Use 4 capfuls of Armor All Shield Snow Foam Car Wash to 5l of water for a lightly soiled car, increase to 8 capfuls for heavily soiled vehicles. Wash car in sections with a sponge, mitt or towel. If your car is heavily soiled, wash in smaller sections at a time. Rinse car immediately and thoroughly with water, then dry with a clean soft microfibre cloth, towel or chamois to avoid water spots. If using a snow foam gun, rinse with water to remove excess road film, dirt and grime. Set up snow foam gun as per manufacturer’s instructions and fill the reservoir with Armor All Shield Snow Foam Car Wash. Do not dilute. Turn on the pressure washer and adjust spray pattern as required. Working from the top down, cover the enTyre surface of the vehicle in foam. Agitate with a wash mitt or sponge before rinsing with clean ater to ensure a proper wash. Repeat if your car is heavily soiled. Once the vehicle is rinsed, dry it with a clean soft microfibre cloth, towel or chamois to avoid water spots. For best results, use on a cool surface away from direct sunlight. The snow foam car wash can be used on all exterior vehicle surfaces.