Rated 4.1 out of 5 by 16
Rated 5 out of 5 by Rob Excellent
Easy to use
Does what it says on the pack
13 April 2016
Rated 1 out of 5 by Rob Useless
This item was completely useless and its strength is laughable. I wish I had purchased a different item, PVA glue is even stronger than this stuff. I am really disappointed and will steer clear of the brand altogether from now on.
12 October 2014
Rated 1 out of 5 by wetandwindy poor
I had to return this item as it had hardened in the tubes - wasn't happy as had 2 wasted journeys ;-)
10 April 2013
Rated 5 out of 5 by Avondale Great Repair Job
When a door knob falls off you would think the repair would be easy. Not when you have an old house with old door knobs that are hard to replace.
No chance to drill and put in new grub screw.
Tried other glues but did not last very long as door is regularly used.
Unibond has done the job.
07 March 2013
Rated 1 out of 5 by paul Poor value for money
Resealable top was hopeless, so for a small initial repair I ended up wasting the whole pack.
09 January 2013
Rated 5 out of 5 by Erni3 Excellent
I had an expensive adjustable hobby lamp with built-in adjustable magnifying glass that had a metal pole holding them to the base. The pole had snapped in half, rendering the lamp useless and held together by just the cable. I used the UniBond Repair Adhesive to pack both ends of the broken pole, along with a piece of metal inserted in the pole. I joined the poles, smoothed the join and supported the lamp during repair.The repair adhesive was workable for a suitable amount of time. After a short time, the lamp was self supporting and now it is stronger than before. Highly recommend keeping this in your tool box.
04 May 2012
Rated 5 out of 5 by musher does whast it says on the tin
I used it to repair a set of skis that were suffering some delamination, and a loose edge. The glue was excellent. The delamination stayed laminated, and the edge stayed stuck. Temperature ranges from +20 to - 20, loads of stresses & water as well. Highly recommended.
14 March 2012
Rated 4 out of 5 by Katie Tricky but very effective
Very difficult to push through the nozzle, so difficult in fact I gave up and took the plunger out and scrapped out the two glues from the wrong end.
Once the two liquids are mixed together they react, and it really does set hard within about two minutes, so only mix up the two glues a little amount at a time.
Drys to a slightly silvery grey colour, with a slight metalic sheen to it. I used it to plug a gap on my cast iron fireplace and it has sealed the gap perfectly. Would definitely use it again, but not attempt to use the plunger!
05 February 2012