Rated 4.5 out of 5 by 4
Rated 5 out of 5 by Lewis Pro-Glider
Having to replace gliders from my kitchen furnitures was the most sensible choice to use this professional glider from Homebase. The old ones where Side Mount Drawer Slide - White - 35cm. Use a pencil to mark up the hole positions makes any mistakes easy to remark.. Start by releasing the glider in-to two pieces by using the releasing leaver, use the existing pre-punched holes to position the drawers. Good advise is take the measurements from centre of the gliders leaving 1-2mm gap from the drawers front then it's just as easy to mark the same height all over. It took no more than 45min from removing the old gliders to have installed the drawers back into place. The slide comes complete with screws for wood fixing and of good quality size 2 pozidrive. Furthermore they have a rubber fix stop that can be removed but is good to leave as a damper when closing the draw. Best of all they fully extend the draw. They do have different lengths but choosed the lengths of my draws which are 35cm. After having those 6 sliders installed for now about 2 months, they still feel solid and no problems at all. Last advice make sure the width fits the sliders otherwise they will separate and you will see loads of balls on the floor, just use washers, shims any gap more than 1 mm will not work properly. Good luck.
12 November 2012
Rated 5 out of 5 by Yaz Excellent quality
Highly recommended. Did the job for me and was very easy to fix as well.
14 March 2012
Rated 3 out of 5 by Jon Ok but !
They need 1/2" clearance each side, not in description,will need to return, not suitable.
30 May 2011
Rated 5 out of 5 by bob lovely
these are lovely and lovely
16 April 2011